Please put a new roll paper. Change the mode to the P position.
Plug in the power code, holding down the c and 1 keys at the same time.

Please set MF001_N7 to "1".

Change the mode to P position.
ENT/RLS → XXXX (Input the password) → ID on/off
1 → X/Time → YY MM DD → Cash/Tend

Change the mode to P positoin.
ENT/RLS → XXXX (Input the password) → ID on/off
2 → X/Time → hh mm → Cash/Tend

Change the mode to P positoin.
ENT/RLS → XXXX (Input the password) → ID on/off
Set the department flags.
RLS → N1 N2 N3 N4 N5 N6 N7 → a Department key
　N1 : 0-9
　　　: The department to one of 10 groups.
　N2 N3 :
　　　01: Enable single-item cash sale
　　　02: Enable negative department sale
　　　03: Enable single-item cash sale and negative department
　N4 N5 : 00 to 69
　　　: High amount lock out . If you press 0, 7 digits will be allowed.
　　　　N4 limits the length of digits while N5 specifies the highest number of amount.
　　　Example: N4 = 4,N5 = 6 : HALO for the department will be 69.99
　　　　70.00 is not allowed.
　N6 N7 :
　　　00: Do not add TAX for the department
　　　01: Add TAX1
　　　02: Add TAX2
　　　03: Add TAX1 and TAX2
　　　04: Add TAX3
　　　05: Add TAX1 and TAX3
　　　06: Add TAX2 and TAX3
　　　07: Add TAX1, TAX2 and TAX3
　　　10: Add TAX4 to the department.
　　　11: Add TAX1 and TAX4.
　　　12: Add TAX2 and TAX4.
　　　13: Add TAX1, TAX2 and TAX4
　　　14: Add TAX3 and TAX4
　　　15: Add TAX1, TAX3 and TAX4
　　　16: Add TAX2, TAX3 and TAX4
　　　17: Add TAX1, TAX2 ,TAX3 and TAX4

Plug in the power code, holding down the c and 1 keys at the same time.

Change the mode to P position.
ENT/RLS → XXXX (Input the password) → ID on/off
Tax rate setting.
n → PO　　* n= tax number (n = 1,2,3 or 4 : Tax1,Tax2,Tax3 or Tax4)
Rate (Max 6 digits) → ENT

Select type of tax.
n → PO　　* n= tax number (n = 5,6,7 or 8 : Tax1,Tax2,Tax3 or Tax4)
x → ENT　　 x = 0: Add on Tax / 1: Value added tax

It is out of roll paper. Please install a new roll paper.

Dry-cell battery capacity is low. Please replace your dry-cell battery.

Mode password has not been entered. Press the CLR key and enter correct password.

Select the mode position.
MODE ( P) --> MODE (L)--> MODE (R ) --> MODE (X) --> MODE (Z) ---> MODE (P) ………
input the mode password
ENT/RLS --> XXXX --> ID on/off
*After initialization the password of each mode is below.　　* the default password can be changed.
P: 1 R: 2 X: 3 Z: 4